POS Rhino Carbon Fiber Shaft
5/10/2025 10:52:03 PM
POS Rhino Carbon Fiber Shaft
I broke the end of my 12.4mm Rhino Carbon fiber shaft after breaking the balls. NOTE: I was not using it as a break cue I just did a few medium power breaks.
I contacted the Rhino Billiards folks on Facebook and they told me that they would not warranty it because I broke with it. Rhino SUCKS.
When it broke I got angry and smacked it on the table and it splintered into a hundred pieces so I sawed it off and now use it for a shorty cue. The foam inside was not attached to the cue but loose inside. I really thought that the foam would have been injected in the shaft instead of just some foam shoved inside.
I bought a new carbon 12.4 on Temu for half the price. It hasn't arrived but when it does I'll give a review.
POS Rhino Carbon Fiber Shaft
Replies & Comments
SATXRON on 5/28/2025 1:51:48 AMI bought a Rhino shaft because it was cheap. I expected it to break but it hasn't, so far. I think the tip is TIME or something like that. It hits pretty good, I guess I got lucky. I play with Cynergy, which I just bought as an impulse buy, then decided to use it as a break cue. I am not a real smasher though. Its holding up for the moment.
When I got it though, it turned my hand black every time I used it, until I used about 5 alcohol wipes on it. Now its okay. They should at least clean them up before shipping them.
That sucks they won't replace it. I have heard the same from local players here in Texas.
They seem to break a few inches below the Ferrule.
BallBuster on 5/28/2025 10:12:30 AMYou can get the same carbon fiber shafts a hell of a lot cheaper on Temu. That's what I did.
F**k Rhino Billiards.
POS Rhino Carbon Fiber Shaft
- Title: POS Rhino Carbon Fiber Shaft
- Author: BallBuster
- Published: 5/10/2025 10:52:03 PM
- Last Updated: 5/30/2025 8:03:48 AM
- Last Updated By: billiardsforum (Billiards Forum)
